Displaying Traffic Accounting 549n ■ The interface module that connects external networks (Internet) should beconfigured as traffic collection modules.■ Currently, only single rate is supported, and multi-rate is not supported.Displaying TrafficAccountingAfter the above configuration, you can execute the display command in any viewto display the operation status of traffic accounting and verify your configuration.Configure the trafficaccounting slottraffic-accountingaccounting-slot slot-numRequired■ The traffic accounting slotyou specified must be theslot where the trafficaccounting moduleresides.■ You will enter the trafficaccounting view directlyafter the configurationsucceeds.■ By default, no trafficaccounting slot isspecified.Specify a traffic collectioncardTraffic-slot slot-num RequiredEnable the traffic accountingfunctionaccounting enable RequiredBy default, this function isdisabled on the trafficaccounting module.Table 430 Configure traffic groupConfiguration Command DescriptionEnter system view system-view -Create a traffic group andenter traffic group viewtraffic-accountingtraffic-group group-nameRequiredConfigure a network addressfor the traffic groupnetwork ip-address { mask |mask-len }RequiredTable 431 Configure a traffic group for a domainConfiguration Command DescriptionEnter system view system-view -Enter ISP domain view domain domain-name -Set the accounting mode totraffic accountingaccounting-mode traffic RequiredBy default, the systemperforms accounting basedon time.Configure the domain to usea specified traffic grouptraffic-group group-namerate idnumRequiredTable 429 Configure the traffic accounting functionOperation Command Description
