566 Fault tracingsource (see parameter 31.11 Fault reset selection) such as the control panel, Drivecomposer PC tool, the digital inputs of the drive, or fieldbus. After the fault is reset,the drive can be restarted. Note that some faults require a reboot of the control uniteither by switching the power off and on, or using parameter 96.08 Control board boot– this is mentioned in the fault listing wherever appropriate.Warning and fault indications can be directed to a relay output or a digital input/outputby selecting Warning, Fault or Fault (-1) in the source selection parameter. Seesections• Programmable digital inputs and outputs (page 71)• Programmable relay outputs (page 72), and• Programmable I/O extensions (page 72). Pure eventsIn addition to warnings and faults, there are pure events that are only recorded in theevent logs of the drive. The codes of these events are included in the Firmwarewarning messages table. Editable messagesFor some warnings and faults, the message text can be edited and instructions andcontact information added. To edit these messages, choose Menu - Settings - Edittexts on the control panel.Warning/fault history and analysis Event logsThe drive has two event logs. One log contains faults and fault resets; the othercontains warnings, pure events, and clearing entries. Each log contains the 64 mostrecent events with a time stamp and other information.The logs can be accessed separately from the main Menu on the control panel. Thelogs are displayed as a single list when viewed using the Drive composer PC tool.Auxiliary codesSome events generate an auxiliary code that often helps in pinpointing the problem.The auxiliary code is displayed on the control panel together with the message. It isalso stored in the event log details. In the Drive composer PC tool, the auxiliary code(if any) is shown in the event listing.Factory data loggerThe drive has a data logger that samples preselected drive values at 500-microsecond (default; see parameter 96.65 Factory data logger time level) intervals.Approximately 7000 samples recorded immediately before and after a fault are saved
