17.8.2 FunctionalityThe rated system frequency and phasor rotation are set under Main menu/Configuration/ Power system/ Primary values/PRIMVAL in the local HMI andPCM600 parameter setting tree.17.8.3 SettingsTable 508:PRIMVAL Non group settings (basic)Name Values (Range) Unit Step Default DescriptionFrequency 50.0 - 60.0 Hz 10.0 50.0 Rated system frequencyPhaseRotation Normal=L1L2L3Inverse=L3L2L1- - Normal=L1L2L3 System phase rotation17.9 Signal matrix for analog inputs SMAI17.9.1 FunctionalitySignal matrix for analog inputs function (SMAI), also known as the preprocessorfunction, processes the analog signals connected to it and gives information about allaspects of the analog signals connected, like the RMS value, phase angle, frequency,harmonic content, sequence components and so on. This information is then used bythe respective functions in ACT (for example protection, measurement ormonitoring).The SMAI function is used within PCM600 in direct relation with the Signal Matrixtool or the Application Configuration tool.The SMAI function blocks for the 650 series of products are possibleto set for two cycle times either 5 or 20ms. The function blocksconnected to a SMAI function block shall always have the same cycletime as the SMAI block.17.9.2 IdentificationFunction description IEC 61850identificationIEC 60617identificationANSI/IEEE C37.2device numberSignal matrix for analog inputs SMAI_20_x - -Section 17 1MRK 502 048-UEN ABasic IED functions638Technical manual
