3-3Installing SCSI Devices4 Connect one end of the 50-pin internal SCSI cable to the SCSIconnector on the card, as shown in the next figure. Ensure thatthe connector fits snugly.Make sure Pin 1 on the cable aligns with Pin 1 on the internalSCSI device connector. Pin 1 is usually designated by a “1” orsmall triangle.5 Connect the other end of the cable to the internal SCSI device.6 If you are installing one internal SCSI device only, you mustterminate this device, then skip to Step 9 on page 3-4.Refer to your SCSI device’s documentation for terminationinstructions.Blue or red stripedenotes Pin 1Standard 50-pininternal SCSI cable(included in kit)Pin 1 markingKeyInternal SCSIconnectorTerminated internalSCSI device Internal SCSI cable
