B-3Configuring the SCSI Card 2930CU with SCSISelectStarting SCSISelectTo start SCSISelect:1 Turn on or restart your computer.2 When this message appears on your screen, immediately pressCtrl+A. (This message appears for only a few seconds.)Press Ctrl+A for SCSISelect (TM) Utility!3 From the menu that appears, use the ↑ and ↓ keys to move thecursor to the option you want to select, then press Enter.Note: If you have difficulty viewing the display, press F5 totoggle between color and monochrome modes. (Thisfeature may not work on all monitors.)Using SCSISelect SettingsTo select an option, use the ↑ and ↓ keys to move the cursor to theoption, then press Enter.In some cases, selecting an option displays another menu. You canreturn to the previous menu at any time by pressing Esc.To restore the original SCSISelect default values, press F6 from themain SCSISelect screen.SCSI Bus Interface Options Host Adapter SCSI ID—Sets the SCSI ID for the SCSI card. TheSCSI Card 2930CU is set at 7, which gives it the highest priorityon the SCSI bus. You should not change this setting.BIOS Support for BootableCD-ROMs2Enabled,DisabledDisabledBIOS Support for Int 13Extensions 2Enabled,DisabledEnabled1 Setting is valid only if Multiple LUN Support is enabled.2 Settings are valid only if host adapter BIOS is enabled.SCSISelect Options Available Settings Default Setting