4-14Installing Drivers10 Press Enter to continue the Windows NT operating systemset-up. Follow the instructions on-screen and in the WindowsNT documentation to complete the installation.Removing the SCSI Card 2930CUIf you physically remove your SCSI Card 2930CU, a warningmessage is generated every time you boot Windows NT. To eliminatethe warning message, remove the driver from your system.Caution: If you have removed a SCSI card but still have otherSCSI cards of the same type installed in your computer, do notuse Windows NT Setup to remove the device driver.To remove a driver from Windows NT1 From the Control Panel, double-click SCSI Adapters.2 Click the Drivers tab.3 Select the driver (aic78xx.sys).4 Click Remove.5 Ensure that you are removing the correct driver, then click Yes.6 Click Yes to restart the computer and initialize changes. ClickNo to return to the SCSI Adapters window.Note: Windows NT Setup does not delete the device driverfrom your system disk; it only updates Windows NT softwareconfiguration information so that the device driver is nolonger loaded during system bootup.!