Adaptec 2930U User Manual

Contents

4-12Installing DriversInstalling the Driver When Installing Windows NTThe driver is embedded on the Windows NT 4.0 CD. During anormal Windows NT installation, the SCSI Card 2930CU is detectedin your system and the embedded driver is automatically installed.Installing the Driver When Windows NT is Already InstalledTo update or install the drivers if Windows NT is already installed1 Start Windows NT.2 Click Start, point to Settings, then click Control Panel.3 Double-click SCSI Adapters, then click the Drivers tab.4 Click Add.5 In the Install Driver window, click Have Disk.6 Insert the SCSI Card 2930 CD into the CD-ROM drive.7 In the Copy Manufacturer’s File From text box, type the driveletter for your CD-ROM drive, and click OK.8 In the Install Driver window, Click OK.The system asks if you want to use the currently installed driveror install a new one.9 Click New.10 Type the drive letter for your CD-ROM drive, then click Continue.The driver is now installed.11 Restart your computer for the changes to take effect.Installing the Driver When Installing Windows NT to a SCSIHard Disk Drive Attached to the SCSI Card 2930CUFollow the appropriate set of instructions for a fresh Windows NTinstallation from either CD or floppy disk.Completing an Installation from CD1 Insert your Windows NT 4.0 CD into your CD-ROM drive, thenturn on your computer.2 Press and release F6 immediately when this message appears:Setup is inspecting your computer’s hardware configuration...