Basic Installation18 AXIS 5570e User’s Manual1. Append the following line to your Ethernet Address table. This is typicallylocated in the /etc/ethers file:Example:2. Update, if necessary, your host table and alias name databases, as requiredby your system.3. If it is not already running, start the RARP daemon. This is typicallyperformed using the rarpd -a command.4. Restart the AXIS 5570e to download the IP address.Notes:Using BOOTPin UNIX/LinuxFollow the instructions below to set the IP address using BOOTP:1. Append the following entry to your boot table. This is typically performedby editing the file: /etc/bootptabExample:The Axis Network Print Server can automatically download a customizedconfig file from a TFTP server. Just add the name of the config file andthe TFTP server’s IP address to your boot table. The config file isdownloaded immediately after the Axis Network Print Server receives itsIP address. 00:40:8c:10:00:86 npsname• The Ethernet address is equal to the serial number, which can be found on the undersidelabel of the AXIS 5570e.• If you are a IBM AIX user, you will probably not have access to a RARP daemon. If this isthe case, you can use either the arp or BOOTP methods instead.:ht=:vm=:\:ha=:ip=:\:sm=:gw=npsname:ht=ether:vm=rfc1048:\:ha=00408c100086:ip=192.168.3.191:\:sm=255.255.255.0:gw=192.168.1.1
