Setting Up - AS/400 (iSeries)AXIS 5570e User’s Manual 291. Type WRKCTLD *VWS on the AS/400 command line and press Enter todetermine the number of auto-configured virtual devices on your AS/400system. Press F3.2. Type DSPSYSVAL QAUTOVRT and press Enter. Make sure that the value ofthe QAUTOVRT parameter is greater than the number of auto-configuredvirtual devices. Press F3.3. Type DSPSYSVAL QCHRID and press Enter. Note the system language (codepage) for future reference. Press F3.4. Type WRKTCPSTS OPTION *IFC and press Enter to determine the IP addressof the AS/400 server. Press F3.Configuring theAxis Network PrintServerFollow the instructions below to configure the Axis Network Print Serverfor TN5250E printing using a Web browser:1. Start a Web browser, e.g. Internet Explorer or Netscape Navigator.2. Enter the IP address or the host name of the Axis Network Print Server inthe location field and press the Enter key on your keyboard. The internal Webpages of the Axis Network Print Server will appear.Important:3. Click the Configuration Wizard for IBM sessions button.4. Click the Add Session button. This takes you to the Configuration Wizardwhich is a step-by-step guide through the required configuration settings.Notes:Verifying theCommunication Link1. Type WRKCFGSTS *DEV xxxx*, where xxxx are the first four characters ofthe printer device name, on the AS/400 command line and press Enter. Alist of printer devices will be displayed. Make sure that a virtual printerdevice is active.2. Direct a printout to this printer device to check the integrity of thecommunication link.3. Press the test button on the Axis Network Print Server once to print a testpage. Make sure that the TN5250E status is defined on the test page asIdle, Actv or LU-1.To protect the admin pages and the Configuration Wizard from unauthorized use, enter apassword (default Pass) in the Root Password field under Admin | General Settings.• In the Configuration Wizard, you must choose a new and unused name for the printer (inthe ‘Printer Name’ field) when in the ‘TN5250E Protocol Configuration’ window.• In the Configuration Wizard’s ‘Printer Driver’ window, PCL is used for LaserWriter printers,all other values apply to matrix printers.
