R5906112 /09 UDX series 312.7 Displaying and Programming addresses intothe RCUDisplaying the Projector Address on the Screen.1. If the projector is on, press the menu key and navigate to the Status page. The projector address and thebroadcast address can be seen under the Communication heading.The projector's address is displayed on the LCD status screen and / or the OSD.How to Program an Address into the RCU?1. Press the Address button until the Button pressed indicator lights up continuously (proximately 5 seconds).2. Enter the address with the digit buttons within the time the indicator lights up (also proximately 5 seconds).Note: That address can be any value between 0 and 31.Tip: A few examples:To enter address 3, press "3" digit button on the RCU to set the RCU's address to 3 and wait until thebutton pressed indicator is out. Alternatively, you can also press “0” and “3”. This way, the buttonpressed indicator goes out immediately.To enter address 31, then press “3” and “1” on the digit button on the RCU and the button pressedindicator goes out immediately.Pulse Remote Control Unit
