R5906112 /09 UDX series383.3 Communication connectionsCommunication Panel321 4 5 6 7 8 9 10 11 12 13Image 3-31 WIFI antenna for wireless IP (optional) 8 RS232 for serial communication2 12V 1A output 9 Sync Out 3D3 Firmware update / USB download log files 10 Sync In 3D4 10/100 base-T for external control over IPand Art-Net 11 Status lights5 DMX interface input 12 IR receive sensor6 DMX interface output 13 GSM antenna input (optional)7 XLR input for wired projector control12 V output12 V output, maximum 1 A, available when projector is not in stand by.DMX interfaceDMX is used as communication bus between different devices in the light technic. Each device has an inputand an output, so that the bus can be looped between the different devices. According the standard a five wirecable with XLR connector is used.You can use the DMX input port to connect a DMX device (DMX console) to the projector. This way you cancontrol the projector from that DMX device (console). The DMX output port can be connected with the nextdevice in the loop.Pin Description1 Earth2 Cold3 Hot4 Return - (or not used)5 Return + (or not used)DMXDMX-512 Lighting protocol over RS-485 interface. Carries information of 512 channels from alighting controller to lighting devices. Standardized by USITT.RS232/RS422 inputThe communication interface of the UDX series projector supports RS232 and RS422 serial communicationon two different types of input connectors, a Sub-D connector and an USB connector acting as RS input whenconnected to an USB input of a PC.You can use the RS232/RS422 input to connect a local PC to your UDX series projector. By this way you canconfigure and control your projector from your local PC.Input & Communication
