R5906112 /09 UDX series 593.10 Installation of an input board or acommunication boardWARNING: The procedures below may only be performed by Barco trained and qualifiedtechnicians.CAUTION: Always wear a wrist band which is connected to the ground while handling theelectrostatic discharge (ESD) sensitive parts.Required toolsPhillips screwdriver PH1The procedure below is applicable to all the input modules of the Input & Communication Unit of theprojector.How to install1. Switch off the projector and unplug the power cord at the projector back side.2. Push the input module in the Input & Communication Unit using the handles. Make sure the module seats inits sliders (2).Pull in the module until the contacts (3) are fully inserted into the connectors.223Image 3-173. Tighten the captive screws of the input module.Input & Communication
