Cabletron Systems CSX200 User Manual

Also see for SPECTRUM: User guide User guide User guide User guide Guide

Contents

About the CSX4002-3Device ConfigurationAbout the CSX400The CSX400 supports multiple LAN options through two Ethernet ports. Theseports can be configured with any combination of the following Cabletron EPIMconnections:EPIM-A Female AUI interface with DB-15 connectorEPIM-C 10Base-2 coaxial port, BNC connectorsEPIM-T 10Base-T twisted pair port with RJ45 connectorEPIM-F1 10BaseFL multi-mode fiber port with SMA connectorsEPIM-F2 10Base-FL multi-mode fiber port with ST connectorsEPIM-F3 802.3 single-mode fiber port with ST connectorsFor more information on these EPIMs, consult your hardware documentation.The CSX400 also consists of two WAN interfaces, which can currently beconfigured with any combination of Cabletron WPIMs, which are described inCSX WPIMs on page 2-4.ApplicationsYou can use the following SPMA applications to manage your CSX400 device:Bridge ViewThe Bridge View application is described in Chapter 3, CSX Bridge View. TheBridge View allows you to configure bridging and filtering parameters, and toview statistics on your CSX400 bridge.Router ConfigurationThe Advanced and Basic Router Configuration applications are both detailed inyour SPMA Routing Services Configuration Guide. Through Basic Configurationyou can set and view routing parameters on each port. With AdvancedConfiguration you can configure static routes and secondary addresses, monitorand control routing tables, and apply network security measures using accesscontrol lists.WAN ConfigurationChapter 4, CSX WAN Configuration, describes this application in detail. With theCSX200’s WAN Configuration window, you can set wide-area protocols andconfigure those settings, as well as configure the WPIM installed on your device.RMON ConfigurationThe RMON application must be purchased separately, and is documented in itsown User’s Guide.