D (Drive) can be used for towing. You may want to shiftthe transmission to 3 (Third) or, if necessary, to alower gear if the transmission shifts too often underheavy loads and/or hilly conditions.See Towing a Trailer on page 5-26 for more information.3 (Third): This position is also used for normaldriving. However, it reduces vehicle speed more thanD (Drive) without using the brakes. You might choose3 (Third) instead of D (Drive) when driving on hilly,winding roads, when towing a trailer, so there is lessshifting between gears and when going down asteep hill.2 (Second): This position reduces vehicle speed morethan 3 (Third) without using the brakes. You can use2 (Second) on hills. It can help control vehicle speed asyou go down steep mountain roads, but then youwould also want to use the brakes off and on.Notice: Do not shift into 2 (Second) unless you aregoing slower than 65 mph (105 km/h), or you candamage the engine and/or transmission.1 (First): This position reduces vehicle speed evenmore than 2 (Second) without using the brakes. You canuse it on very steep hills, or in deep snow or mud.If the shift lever is put in 1 (First) while the vehicle ismoving forward, the transmission will not shift into firstgear until the vehicle is going slowly enough.Notice: Spinning the tires or holding the vehicle inone place on a hill using only the acceleratorpedal may damage the transmission. The repair willnot be covered by the vehicle warranty. If youare stuck, do not spin the tires. When stopping on ahill, use the brakes to hold the vehicle in place.Performance ShiftingIf the vehicle has this feature, it can detect a change indriving patterns. If you make an aggressive drivingmaneuver, the vehicle’s transmission automatically shiftsto the lowest possible gear to maximize vehicleperformance. The vehicle will automatically return tonormal operation when you return to normal drivingpatterns.3-29
