10. Inflate the tire to the recommended inflationpressure using the pressure gage (D). Therecommended inflation pressure can be found onthe Tire and Loading Information label.See Inflation - Tire Pressure on page 6-54.The pressure gage (D) may read higher than theactual tire pressure while the compressor is on.Turn the compressor off to get an accurate reading.The compressor may be turned on/off until thecorrect pressure is reached.11. Press the on/off button (A) to turn the tire sealantand compressor kit off.Be careful while handling the tire sealant andcompressor kit as it could be warm after usage.12. Unplug the power plug (G) from the accessorypower outlet in the vehicle.13. Disconnect the air only hose (E) from the tire valvestem, by turning it counterclockwise, and replacethe tire valve stem cap.14. Replace the air only hose (E) and the powerplug (G) and cord back in its original location.15. Place the equipment in the original storage locationin the vehicle.Removal and Installation of the SealantCanisterTo remove the sealant canister:1. Remove the plastic cover.2. Unscrew the connector (B) from the canister (A).3. Pull up on the canister (A) to remove it.4. Replace with a new canister which is available fromyour dealer/retailer.5. Push the new canister into place.6. Screw the connector (B) to the canister (A).7. Slide the plastic cover back on.6-78