It is recommended that the vehicle is taken to yourdealer/retailer for service if the headlamps need to bere-aimed. It is possible however, to re-aim theheadlamps as described.Notice: To make sure the headlamps are aimedproperly, read all the instructions before beginning.Failure to follow these instructions could causedamage to headlamp parts.The vehicle should:• Be placed so the headlamps are 25 ft. (7.6 m) froma light colored wall.• Have all four tires on a level surface which is levelall the way to the wall.• Be placed so it is perpendicular to the wall.• Not have any snow, ice, or mud on it.• Be fully assembled and all other work stopped whileheadlamp aiming is being performed.• Be normally loaded with a full tank of fuel and oneperson or 160 lbs (75 kg) sitting on the driver seat.• Have all tires properly inflated.• Have the spare tire is in its original location in thevehicle.Headlamp aiming is done with the vehicle’s low-beamheadlamps. The high-beam headlamps will be correctlyaimed if the low-beam headlamps are aimed properly.To adjust the vertical aim:1. Open the hood. See Hood Release on page 6-11for more information.2. Find the center line running through the lens of theheadlamp.3. Record the distance from the ground to the centerline running through the lens of the headlamp.6-41
