RELEARN REMOTE KEYThis display allows you to match Remote KeylessEntry (RKE) transmitters to your vehicle. This procedurewill erase all previously learned transmitters. Therefore,they must be relearned as additional transmitters.To match an RKE transmitter to your vehicle:1. Press the vehicle information button untilPRESS V TO RELEARN REMOTE KEY displays.2. Press the set/reset button until REMOTE KEYLEARNING ACTIVE is displayed.3. Press and hold the lock and unlock buttons on thefirst transmitter at the same time for about15 seconds.On vehicles with memory recall seats, the firsttransmitter learned will match driver 1 andthe second will match driver 2.A chime will sound indicating that the transmitter ismatched.4. To match additional transmitters at this time, repeatStep 3.Each vehicle can have a maximum of eighttransmitters matched to it.5. To exit the programming mode, you must cycle thekey to LOCK/OFF.Blank DisplayThis display shows no information.DIC Warnings and MessagesThese messages appear if there is a problem detectedin one of your vehicle’s systems.You must acknowledge a message to clear it from thescreen for further use. To clear a message, pressthe set/reset button.Be sure to take any message that appears on thescreen seriously and remember that clearing themessage will only make the message disappear, notthe problem.ADVISORY XXX MPH (km/h)This message displays when the Speed Alert has beenturned on through the DIC Information Menu and thevehicle is at or above the advised speed. See DICOperation and Displays on page 4-62.AUTOMATIC LIGHT CONTROL OFFThis message displays when the automatic headlampsare turned off. See Exterior Lamps on page 4-25 formore information.4-67