The system operates in the delay mode. If the system isleft on for long periods of time, occasional wipes mayoccur without any moisture on the windshield. Thisis normal and indicates that the Rainsense™ systemis active.The Rainsense™ system is activated by turning thewiper control band to one of the five sensitivity levelswithin the delay area. The position closest to off isthe lowest sensitivity setting, level one. This allows morerain or snow to collect on the windshield betweenwipes. Turning the wiper band away from you to highersensitivity levels increases the sensitivity of thesystem and frequency of wipes. The highest sensitivitysetting, level five is closest to low. A single wipe willoccur each time you turn the wiper stalk to a highersensitivity level to indicate that the sensitivity level hasbeen increased.Notice: Going through an automatic car wash withthe wipers on can damage them. Turn the wipersoff when going through an automatic car wash.The MIST and wash cycle operates as normal and arenot affected by the Rainsense™ function. The systemcan be overridden at any time by manually changing thewiper control to low or high speed.Notice: Do not place stickers or other items on theexterior glass surface directly in front of the rainsensor.Windshield Washer{ WARNING:In freezing weather, do not use your washer untilthe windshield is warmed. Otherwise the washerfluid can form ice on the windshield, blockingyour vision.J (Washer Fluid): Press and release this paddle,located at the top of the turn signal/multifunction lever, tospray washer fluid on the windshield. The wipers willclear the windshield and either stop or return tothe preset speed. For more washer cycles, press andhold the paddle.4-11