5. After entering all of the switch positions, again,firmly press and release all three buttons at thesame time. The indicator lights will turn on.6. Press and hold the button that will be used tocontrol the garage door until the garage doormoves. The indicator light above the selected buttonshould slowly blink. This button may need to beheld for up to 55 seconds.7. Immediately release the button when the garagedoor moves. The indicator light will blink rapidlyuntil programming is complete.8. Press and release the same button again. Thegarage door should move, confirming thatprogramming is successful and complete.To program another Fixed Code device such as anadditional garage door opener, a security device,or home automation device, repeat Steps 1-8, choosinga different button in Step 6 than what was used forthe garage door opener.Using Universal Home RemotePress and hold the appropriate button for at least half ofa second. The indicator light will come on while thesignal is being transmitted.Reprogramming Universal HomeRemote ButtonsAny of the three buttons can be reprogrammed byrepeating the instructions.Erasing Universal Home RemoteButtonsThe programmed buttons should be erased when thevehicle is sold or the lease ends.To erase either Rolling Code or Fixed Code on theUniversal Home Remote device:1. Press and hold the two outside buttons at the sametime for approximately 20 seconds, until theindicator lights, located directly above the buttons,begin to blink rapidly.2. Once the indicator lights begin to blink, release bothbuttons. The codes from all buttons will be erased.For help or information on the Universal Home RemoteSystem, call the customer assistance phone numberunder Customer Assistance Offices on page 8-6.3-54