16. If the flat tire was ableto inflate to therecommended inflationpressure, removethe maximum speedlabel from the sealantcanister and placeit in a highly visiblelocation. The label is areminder not toexceed 55 mph(90 km/h) until thedamaged tire isrepaired or replaced.17. Return the equipment to its original storage locationin the vehicle.18. Immediately drive the vehicle 5 miles (8 km) todistribute the sealant in the tire.19. Stop at a safe location and check the tire pressure.Refer to Steps 1 through 11 under “Using the TireSealant and Compressor Kit without Sealant toInflate a Tire (Not Punctured).”If the tire pressure has fallen more than 10 psi(68 kPa) below the recommended inflation pressure,stop driving the vehicle. The tire is too severelydamaged and the tire sealant cannot seal the tire.See Roadside Service on page 8-7.If the tire pressure has not dropped more than10 psi (68 kPa) from the recommended inflationpressure, inflate the tire to the recommendedinflation pressure.20. Wipe off any sealant from the wheel, tire, andvehicle.21. Dispose of the used sealant canister and sealant/airhose (F) assembly at a local dealer/retailer or inaccordance with local state codes and practices.22. Replace it with a new canister available from yourdealer/retailer.23. After temporarily sealing a tire using the tire sealantand compressor kit, take the vehicle to an authorizeddealer/retailer within a 100 miles (161 km) of drivingto have the tire repaired or replaced.6-76
