Black plate (57,1)Cadillac CTS Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-6081492) - 2014 - CRC 1st Edition - 7/2/13Instruments and Controls 5-57does not flash, press and holdthe same button a second timefor two seconds, then release it.Again, if the door does not moveor the garage door lamp doesnot flash, press and hold thesame button a third time fortwo seconds, then release it.The Universal Remote systemshould now activate thegarage door.Repeat the process forprogramming the two remainingbuttons.Radio Signals for Canada andSome Gate OperatorsFor questions or programming helpcall 1-800-355-3515 or seewww.homelink.com.Canadian radio-frequency laws andsome U.S. gate operators requiretransmitter signals to time out or quitafter several seconds oftransmission. This may not be longenough for the Universal Remotesystem to pick up the signal duringprogramming.If the programming did not work,replace Step 2 under “Programmingthe Universal Remote System” withthe following:Press and hold the UniversalRemote system button whilepressing and releasing thehand-held transmitter button everytwo seconds until the signal hasbeen successfully accepted by theUniversal Remote system. TheUniversal Remote system indicatorlight will flash slowly at first and thenrapidly. Proceed with Step 3 under“Programming the Universal RemoteSystem” to complete.Universal Remote SystemOperationUsing the Universal RemoteSystemPress and hold the appropriateUniversal Remote system button forat least one-half second. Theindicator light will come on while thesignal is being transmitted.Erasing Universal RemoteSystem ButtonsErase all programmed buttons whenvehicle ownership is terminated.To erase:1. Press and hold the two outsidebuttons until the indicator lightbegins to flash. This should takeabout 10 seconds.2. Release both buttons.