Black plate (7,1)Cadillac CTS Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-6081492) - 2014 - CRC 1st Edition - 7/2/13Keys, Doors, and Windows 2-73. Wait for 10 minutes until the DICdisplays PRESS ENGINESTART BUTTON TO LEARNand then press the ENGINESTART/STOP button.The DIC display will again showREMOTE LEARN PENDING,PLEASE WAIT.4. Repeat Step 3 two additionaltimes. After the third time allpreviously known transmitterswill no longer work with thevehicle. Remaining transmitterscan be relearned during the nextsteps.The DIC display should nowshow READY FOR REMOTE# 1.5. Place the new transmitter in thetransmitter pocket. The centerconsole storage area will needto be opened and the rubber matneeds to be removed to accessthe transmitter pocket.6. Press the ENGINE START/STOP button. When thetransmitter is learned, the DICdisplay will show that it is readyto program the next transmitter.7. Remove the transmitter from thetransmitter pocket and press Kor Q on the transmitter.To program additionaltransmitters, repeat Steps 5–7.When all additional transmittersare programmed, press and holdthe ENGINE START/STOPbutton for approximately12 seconds to exitprogramming mode.8. Return the vehicle key back intothe transmitter.Starting the Vehicle with a LowTransmitter BatteryIf the transmitter battery is weak or ifthere is interference with the signal,the DIC may display NO REMOTEDETECTED or NO REMOTE KEYWAS DETECTED PLACE KEY INTRANSMITTER POCKET THENSTART YOUR VEHICLE whenstarting the vehicle. See Key andLock Messages on page 5-40.
