Making a Copy With the Express Copy Basic Features Screen7-207Using the Express Copy Basic Features ScreenIMPORTANT• If you want to copy an A3 original with an image that extends all the way to the edges without theperiphery of the original being cut off, load the stack bypass with 305 mm x 457 mm or 320 mm x450 mm paper, or load a paper drawer with 320 mm x 450 mm paper. (See Chapter 2, "BasicOperations," in the Reference Guide and "Slightly Reducing Images to Prevent the OriginalPeriphery from Being Trimmed (Entire Image)," on p. 7-15.)• The following types of originals cannot be copied by using Automatic Paper Selection. Copythese using Manual Paper Selection:- Non-Standard sized originals- Highly transparent originals, such as transparencies- Originals with an extremely dark background- A6R or smaller originals- A5R originals that are placed on the platen glass● If you select stack bypass settings:❑ Press [All].❑ Press [Stack Bypass Settings].❑ Select the paper size ➞ press [Next].IMPORTANT• If you select a nonstandard size paper, the Poster, Rotate Collate, Rotate Group, Offset Collate,Offset Group, Staple, Book 2-Sided, 2-Page Separation, Front Cover/Back Cover, PaperInsertion, Image Combination, Booklet, Tab Paper Creation, Job Block Combination, or Store InUser Inbox mode cannot be specified.If you want to select the 1 2-Sided or 2 2-Sided mode and nonstandard size paper, selectthe paper size after setting the 1 2-Sided or 2 2-Sided mode. The following nonstandardpaper sizes can be used with the 1 2-Sided and 2 2-Sided modes:- Width (X axis): 182 mm to 457 mm- Length (Y axis): 105 mm to 305 mm• If the envelope type is not set correctly, a paper jam will occur.• Do not use envelopes that have glue attached to their flaps, as the glue may melt due to the heatand pressure of the fixing unit.• If you select [Envelope], the Poster, Finishing, 1 2-Sided, 2 2-Sided, Book 2-Sided,2-Page Separation, Front Cover, Back Cover, Paper Insertion, Booklet, TransparencyInterleaving, Image Combination, Form Composition, Tab Paper Creation, or Job BlockCombination mode cannot be specified.
