Finisher-W1/Saddle Finisher-W2/Puncher Unit-AG1 3-233Optional Equipmenta Top Cover of the FinisherOpen this cover to remove jammed paper. (See "Inside theTop Cover of the Finisher-W1/Saddle Finisher-W2(Optional)," on p. 8-43.)b Top Cover of the Puncher Unit-AG1Open this cover to remove jammed paper. (See "PuncherUnit-AG1 (Optional)," on p. 8-58.)c Release LeverPress this lever to move the finisher away from the mainunit.d Front Cover of the Punch Waste TrayOpen this cover to remove punch waste or to removejammed paper. (For instructions on removing punch waste,see "Removing Punch Waste," on p. 7-29. For instructionson clearing a paper jam, see "Puncher Unit-AG1(Optional)," on p. 8-58.)e Front Cover of the Finisher-W1Open this cover to replace the staple cartridge in thestapler unit, or to clear a staple jam. (For instructions onreplacing the staple cartridge, see "Replacing the StapleCartridge in the Stapler Unit," on p. 7-22. For instructionson clearing a staple jam, see "Finisher-W1/SaddleFinisher-W2 (Optional)," on p. 8-65.)f Front Cover of the Saddle Finisher-W2Open this cover to replace the staple cartridge, removejammed paper, or clear a staple jam in the stapler unit andsaddle stitcher unit. (For instructions on replacing the staplecartridge in the stapler unit, see "Replacing the StapleCartridge in the Stapler Unit," on p. 7-22. For instructionson replacing the staple cartridge in the saddle stitcher unit,see "Replacing the Staple Cartridge in the Saddle StitcherUnit," on p. 7-26. For instructions on clearing a paper jam,see "Inside the Front Cover of the Saddle Finisher-W2(Optional)," on p. 8-51, and "Saddle Stitcher Unit(Optional)," on p. 8-54. For instructions on clearing a staplejam in the stapler unit, see "Finisher-W1/SaddleFinisher-W2 (Optional)," on p. 8-65. For instructions onclearing a staple jam in the saddle stitcher unit, see "SaddleStitcher Unit (Optional)," on p. 8-68).g Booklet Tray (Saddle Finisher-W2 Only)Prints that are saddle stitched are output to this tray.h Booklet Tray Guide (Saddle Finisher-W2 Only)Set this guide to match the size of the output paper. (See"Finishing Modes," on p. 3-24.)i Lower TrayPrints are output to this tray. You can set the TrayDesignation mode to designate this tray for outputting printswhen using certain functions. (See "Output TrayDesignation," on p. 4-38.)j Upper TrayPrints are output to this tray. You can set the TrayDesignation mode to designate this tray for outputting printswhen using certain functions. (See "Output TrayDesignation," on p. 4-38.)k Non Collating TrayPrints are output to this tray. You can set the TrayDesignation mode to designate this tray for outputting printswhen using certain functions. (See "Output TrayDesignation," on p. 4-38.)
