Entering Characters from the Touch Panel Display2-282Basic OperationsNOTE• If you make a mistake when entering characters, press [ ] or [ ] to position the cursor➞press [Backspace] to delete the characters➞ enter the correct characters.• To delete all of the characters you have entered, press .• The available entry modes, and the maximum number of characters that you can enter vary,depending on the type of entries you are making.2 When you have entered all characters, press [OK].Values in InchesIf you want to enter values in inches in all modes which require a numeric entry, set Inch Entryto 'On' in Common Settings (from the Additional Functions screen). (See "Inch Entry," onp. 4-31.) This enables you to enter values in inches when you press [Inch] on a screen requiringa numeric entry or measurement.The following example shows you how to enter 1 1/2" for Original Size in the Zoom Programmode.1 Press [1] ➞ [_] ➞ [1] ➞ [/] ➞ [2] using the numeric keys on the touchpanel display.NOTE• If you make a mistake when entering values, press [C] on the touch panel display➞ enter thecorrect values.• You can enter only 2, 4, 8, or 16 as the denominator.• The value entered in inches is converted to millimetres by the machine each time it is entered.Thus, there may be a slight difference between the value calculated and the actual valueentered.• To enter values in millimetres, press [mm].
