List of Error Messages8-748 TroubleshootingReturn page 1 to the top, and then press the Start key.Cause Scanning was stopped due to a problem with the optional feeder.Remedy Arrange the originals in page order with the first page on top. Place the originals back into thefeeder's original supply tray, and press .Return page 1 to the top, and then press the Start key. (Data for the scanned original has exceededlimits on the size that can be handled by this machine. Automatically adjust settings and try again.)Cause Scanning was stopped because the data size of the scanned original exceeded themaximum data size that the machine can handle.Remedy Try scanning the original again from the first page. If scanning is still not possible, reduce theSharpness mode setting, and select [Text] for the original type.Scanning has stopped because the size of the data for the scanned original exceeds the limit. Scanningmay be possible if [Sharpness] is reduced and the type of original is set to [Text].Cause Scanning was stopped because the data size of the scanned original exceeded themaximum data size that the machine can handle.Remedy Reduce the Sharpness mode settings, and select [Text] for the original type.Remove the paper from the output tray.Cause Prints from the previous job remain in the output tray.Remedy Remove the prints remaining in the output tray. Printing automatically resumes.Remove the paper from the booklet tray.Cause Prints from the previous job remain in the Booklet tray of the optional Saddle Finisher-W2.Remedy Remove the prints remaining in the Booklet tray. Printing automatically resumes.
