Chapter 2 Setting Up Your MultiPASS C70 2-39Setting Up YourMultiPASS C70Loading PaperThis section describes how to load plain paper in the multi-purpose trayso that you can begin using your MultiPASS C70. For complete detailson print media specifications and other guidelines for selecting andloading print media, refer to Chapter 5, Paper Handling.Paper Guidelines❏ To avoid paper jams and poor print quality, never try to print ondamp, curled, wrinkled, or torn paper.❏ Store paper and other media flat, and leave it in its wrapper untilyou are ready to use it. Store unused paper from opened packs inthe original packing in a cool, dry location.❏ Store paper at 18°–24°C, 40%–60% relative humidity.❏ Let the paper run out before you refill the multi-purpose tray. Avoidmixing “new” paper with paper remaining in the multi-purposetray.❏ Use cut-sheet paper only, not paper that comes on a roll.❏ Do not use paper that is thicker than that specified for theMultiPASS C70. Printing with paper that is thick enough to come incontact with the print head nozzles may damage the BJ cartridge.For complete paper specifications, refer to Chapter 5, Paper Handling.❏ If your printed page contains a large amount of graphics, the ink onthe page may be damp due to the print density. Leave the page inthe output tray for 30 to 60 seconds to allow the ink to dry. Thenremove the page being careful not to touch the document tray orextension. Should you dirty the document tray or extension whenremoving the page, wipe them clean with a clean, soft, lint-free clothmoistened with water or diluted dishwashing detergent solution.
