COPYRIGHT © 1997 CANON INC. CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)CHAPTER 11 TROUBLESHOOTING11-637. Registering the Paper Width Basic Value (]]4]]; cassette/multifeeder)Perform the steps that follow whenever you have• replaced the machine’s paper width detecting VR (including the multifeeder); or• adjusted the front/rear registration of the cassette.For each cassette, 3 and 4, you must work on ‘STMTR’ and ‘A4R’; for themultifeeder, you must work on ‘A6R’, ‘A4R’, and ‘A4’.a. Cassettes 3 and 4In the case of the cassette 3,1) Start service mode (]4]), and select the 8th screen.2) Slide out the cassette 3, and set the paper width guide plate inside to STMTR; then,slide the cassette into the machine.3) Press ‘C3_STMTR’ on the screen on the control panel.4) Press the ] key.• Check to make sure that the value XXXX indicated under ‘C3_STMTR: XXX’ isthe same as ‘(XXX)’.5) Slide out the cassette 3, and set the paper width guide plate inside the cassette toA4R; then, slide the cassette into the machine.6) Press ‘C3_A4R’ on the screen on the control panel.7) Press the ] key.• Check to make sure that the value YYY indicated under ‘C3_A4R: YYY’ is thesame as ‘(YYY)’.b. MultifeederPerform the steps shown for the cassette 3 and 4; however, you must perform themfor A6R, A4R, and A4.Figure 11-250A6R (105mm)Paper GuideGuideDownload service manual and resetter printer at http://printer1.blogspot.com
