Canon PIXMA MP830 User Manual

Also see for PIXMA MP830: Supplementary guide Start here User guide Quick start guide Service manual

~ ImportantDo not load the paper beyond this Load Limit Mark (A).W Note• You can use general copy paper or Canon's Super White Paper SW-201.• You can load up to 150 sheets of plain paper (64 gsm or 17 Ib, 13 mm or 0.52 inches inheight) in the Auto Sheet Feeder. However, the paper may not be fed normallydepending on its media type or your environment where the temperature and humidityare high or low. In that case, reduce the amount of paper to half (approx. 0.2" / 5 mm inheight).• Remove the printed sheets from the Paper Output Tray before the count reaches 50.• Do not touch the printed surfaces until the ink dries. For specific drying times, refer tothe instructions packaged with your media.• Loading EnvelopesUse either European DL or US Comm. Env. #10 size envelopes.~ Important• Envelopes can be used only when printing from a computer.• Do not use envelopes with embossed or treated surfaces, a double flap, pressure seals orsticker flaps.• Select either [DL Env.] or [Comm. Env. #10] according to the envelope size you are using.• The printed image will be upside down depending on the application. If this occurs, openthe printer properties dialog box then select the [Rotate 180 degrees] check box on the[Page Setup] tab.For information on the printer driver settings, refer to the Printer Driver Guide.1 Load the envelope against the Cover Guide on the right side of the Paper Supportwith the print side facing UP, and the rear flaps DOWN on the left.~ ImportantEnsure that the Cover Guide stands when you load paper in the Auto Sheet Feeder.Chapter 1 Before Printing 29~ ImportantDo not load the paper beyond this Load Limit Mark (A).W Note• You can use general copy paper or Canon's Super White Paper SW-201.• You can load up to 150 sheets of plain paper (64 gsm or 17 Ib, 13 mm or 0.52 inches inheight) in the Auto Sheet Feeder. However, the paper may not be fed normallydepending on its media type or your environment where the temperature and humidityare high or low. In that case, reduce the amount of paper to half (approx. 0.2" / 5 mm inheight).• Remove the printed sheets from the Paper Output Tray before the count reaches 50.• Do not touch the printed surfaces until the ink dries. For specific drying times, refer tothe instructions packaged with your media.• Loading EnvelopesUse either European DL or US Comm. Env. #10 size envelopes.~ Important• Envelopes can be used only when printing from a computer.• Do not use envelopes with embossed or treated surfaces, a double flap, pressure seals orsticker flaps.• Select either [DL Env.] or [Comm. Env. #10] according to the envelope size you are using.• The printed image will be upside down depending on the application. If this occurs, openthe printer properties dialog box then select the [Rotate 180 degrees] check box on the[Page Setup] tab.For information on the printer driver settings, refer to the Printer Driver Guide.1 Load the envelope against the Cover Guide on the right side of the Paper Supportwith the print side facing UP, and the rear flaps DOWN on the left.~ ImportantEnsure that the Cover Guide stands when you load paper in the Auto Sheet Feeder.Chapter 1 Before Printing 29