• Entering the Date And TimeEel NoteWhen your machine is connected to a computer with the MP Drivers installed, the date andtime will be read from your computer every time you start the computer, turn the machine on,or connect the USB cable.The date and time will be reset when you disconnect the power cord or there is a powerfailure. In this case, you can set it again on the machine. Alternatively, it can be read fromyour computer and set on the machine by connecting the machine to your computer with theMP driver installed.1 Display the FAX menu.See "Display the FAX menu." on page 81.2 Display the Device settings screen.See "Display the Device settings screen." on page 81.3 Display the User settings screen.See "Display the User settings screen." on page 81.4 Display the Date/time setting screen.Use [A] or ["Y] to select , then press [OK].(1 )OK "::::et5 Enter the date and time.(1) Use the Numeric buttons to enter the date and time (in 24-hour format), then press [OK].Enter only the last two digits of the year.YlDate/tlme t,ettmg03/1112006 01: 55OK "':::etEel Note• If you misentered the date and time, use [ .... ] or [ ... ] to move the cursor under thenumber to enter the correct number.• Three formats of date are available. For details on the date format settings, see "Datedisplay" on page 138.84 Faxing Chapter 5• Entering the Date And TimeEel NoteWhen your machine is connected to a computer with the MP Drivers installed, the date andtime will be read from your computer every time you start the computer, turn the machine on,or connect the USB cable.The date and time will be reset when you disconnect the power cord or there is a powerfailure. In this case, you can set it again on the machine. Alternatively, it can be read fromyour computer and set on the machine by connecting the machine to your computer with theMP driver installed.1 Display the FAX menu.See "Display the FAX menu." on page 81.2 Display the Device settings screen.See "Display the Device settings screen." on page 81.3 Display the User settings screen.See "Display the User settings screen." on page 81.4 Display the Date/time setting screen.Use [A] or ["Y] to select , then press [OK].(1 )OK "::::et5 Enter the date and time.(1) Use the Numeric buttons to enter the date and time (in 24-hour format), then press [OK].Enter only the last two digits of the year.YlDate/tlme t,ettmg03/1112006 01: 55OK "':::etEel Note• If you misentered the date and time, use [ .... ] or [ ... ] to move the cursor under thenumber to enter the correct number.• Three formats of date are available. For details on the date format settings, see "Datedisplay" on page 138.84 Faxing Chapter 5
