Setting Up a Computer as a File Server4-184Using a NetWare Network (Windows)Setting Up a Computer as a File ServerTo send data from the machine to a computer on your network, you need to specifythe settings of the computer for receiving data.This section describes how to set up a computer as a file server.IMPORTANT• You can only send data from the machine if the optional equipment is installed. For theequipment needed, see "Optional Equipment and System Environment Requirements,"on p. 1-2.• To send a file to the NetWare server, make the following NetWare settings of themachine. For instructions on how to specify the protocol settings, see "Protocol Settings,"on p. 4-9.- : [On]- The Frame Type drop-down list: Frame type suitable for your environment• This section describes only the procedures for setting up a computer receiving data sentfrom the machine. To send data from the machine to a server on the network, you mustenter an address setting from the control panel. For instructions on how to specifyrecipient address settings, see Chapter 2, "Basic Sending Methods," in the Sending andFacsimile Guide.• In some environments, additional detailed settings, such as authority settings, may berequired. For details, consult the network manager of the environment you are using.1 Log in to NetWare as Administrator (or as a user of equivalentauthority).2 Set up the users and passwords for sending data from themachine.Enter a user name, and a password not longer than 24 alphanumeric characters.3 Create a directory to be used for recipient addresses, andthen enable read access and write access by the users whowill be sending data.
