2010080120100801ε-6Using the Setup Wizardk Outputting the Waveform of a Function through the SpeakerNormally, the Setup Wizard helps you configure setups for sensors connected to the EA-200. If you select [CASIO] - [Speaker] - [y=f(x)] on the “Select Sensor” screen, however, itconfigures the EA-200 to output the sound that corresponds to a function that you input andgraph on the calculator.• To configure a setup for speaker output1. Connect the data communication cable (SB-62) to the communication port of thecalculator and the MASTER port of the EA-200.2. Perform the first two steps of the procedure under “To configure an EA-200 setup usingSetup Wizard” on page ε-2.3. On the “Select Sensor” screen, select [CASIO] - [Speaker] - [y=f(x)].This displays a screen like the one shown nearby.4. Press w to advance to the View Window setting screen.• The following settings are configured automatically: Ymin = –1.5 and Ymax = 1.5. Donot change these settings.5. Press w or J to advance to the graph relation list.6. In line “Y1”, input the function of the waveform for the sound you want to input.• Note that the angle unit is always radians.• Input a function where the value of “Y” is within therange of –1.5 to +1.5.7. Press 6(DRAW) to graph the function.• This graphs the function and displays a verticalcursor line as shown in the sample display nearby.Use the graph to specify the range that you want tooutput to the speaker.8. Use the d and e cursor keys to move the cursor to the start point of the output, andthen press w to register it.
