2010080120100801ε-25Using Setup Memoryk Using and Managing Setups in Setup MemoryAll of the setups you save are shown in the setup memory list. After selecting a setup in thelist, you can use it to sample data or you can edit it.• To preview saved setup dataYou can use the following procedure to check the contents of a setup before you use it forsampling.1. On the E-Con2 main menu (page ε-1), press 2(MEMORY) to display the setup memorylist.2. Use the f and c cursor keys to highlight the name of the setup you want.3. Press K(Setup Preview).• This displays the preview dialog box.4. To close the preview dialog box, press J.• To recall a setup and use it for samplingBe sure to perform the following steps before starting sampling with the EA-200.1. Connect the calculator to the EA-200.2. Turn on EA-200 power.3. In accordance with the setup you plan to use, connect the proper sensor to theappropriate EA-200 channel.4. Prepare the item whose data is to be sampled.5. On the E-Con2 main menu (page ε-1), press 2(MEMORY) to display the setup memorylist.6. Use the f and c cursor keys to highlight the name of the setup you want.7. Press 1(START).8. In response to the confirmation message that appears, press 1.• Pressing w sets up the EA-200 and then starts sampling.• To clear the confirmation message without sampling, press 6.Note• See “Operations during a sampling operation” on page ε-31 for information aboutoperations you can perform while a sampling operation is in progress.
