2010080120100801ε-7Using the Setup Wizard9. Use the d and e cursor keys to move the cursor to the end point of the output, andthen press w to register it.• After you specify the start point and end point, an output frequency dialog box shownbelow appears on the display.→10. Input a percent value for the output frequency value you want.• To output the original sound as-is, specify 100%. To raise the original sound by oneoctave, input a value of 200%. To lower the original sound by one octave, input a valueof 50%.11. After inputting an output frequency value, press w.• This outputs the waveform between the start point and end point from the EA-200speaker.• If the sound you configured cannot be output for some reason, the message “RangeError” will appear. If this happens, press J to scroll back through the previous settingscreens and change the setup as required.12. To terminate sound output, press the EA-200 [START/STOP] key.13. Press w.• This displays a screen like the one shown nearby.14. Perform one of the following operations, depending on what you want to do.To change the output frequency and try again:Press 1(Yes) to return to the “Output Frequency” dialog box. Next, repeat the abovesteps from step 10.To change the output range of the waveform graph and try again:Press 6(No) to return to the graph screen in step 7. Next, repeat the above steps fromstep 8.To change the function:Press 6(No) and then J to return to the graph relation list in step 6. Next, repeat theabove steps from step 6.To exit the procedure and return to the E-Con2 main menu:Press 6(No) and then press J twice.
