temperature is within threshold of %dC)MAJOR_TEMP: Major alarm: chassis temperature high (%s temperature reaches orexceeds threshold of %dC)MAJOR_TEMP_CLR: Major alarm cleared: chassis temperature lower (%s %dtemperature is within threshold of %dC)envmon fanFAN_TRAY_BAD: Major alarm: fantray %d is missing or downFAN_TRAY_OK: Major alarm cleared: fan tray %d presentFAN_BAD: Minor alarm: some fans in fan tray %d are downFAN_OK: Minor alarm cleared: all fans in fan tray %d are goodvltEnable VLT traps.vrrpEnable VRRP state change trapsxstp%SPANMGR-5-STP_NEW_ROOT: New Spanning Tree Root, Bridge ID Priority 32768,Address 0001.e801.fc35.%SPANMGR-5-STP_TOPOLOGY_CHANGE: Bridge port TenGigabitEthernet 11/38 transitionedfrom Forwarding to Blocking state.%SPANMGR-5-MSTP_NEW_ROOT_BRIDGE: Elected root bridge for instance 0.%SPANMGR-5-MSTP_NEW_ROOT_PORT: MSTP root changed to port Te 11/38 for instance0. My Bridge ID: 40960:0001.e801.fc35 Old Root: 40960:0001.e801.fc35 New Root:32768:00d0.038a.2c01.%SPANMGR-5-MSTP_TOPOLOGY_CHANGE: Topology change BridgeAddr: 0001.e801.fc35 MstpInstance Id 0 port Te 11/38 transitioned from forwarding to discarding state.ecfm%ECFM-5-ECFM_XCON_ALARM: Cross connect fault detected by MEP 1 in Domaincustomer1 at Level 7 VLAN 1000%ECFM-5-ECFM_ERROR_ALARM: Error CCM Defect detected by MEP 1 in Domain customer1at Level 7 VLAN 1000%ECFM-5-ECFM_MAC_STATUS_ALARM: MAC Status Defect detected by MEP 1 in Domainprovider at Level 4 VLAN 3000%ECFM-5-ECFM_REMOTE_ALARM: Remote CCM Defect detected by MEP 3 in Domaincustomer1 at Level 7 VLAN 1000%ECFM-5-ECFM_RDI_ALARM: RDI Defect detected by MEP 3 in Domain customer1 atLevel 7 VLAN 1000dot1brBRM-5-PE_UNIT_DOWN: PE:6 Unit:0 Unit MAC:00:01:02:03:04:05 operationally downBRM-5-PE_UP: PE:6 MAC:00:01:02:03:04:05 is operationally upThe following example applies when you have configured support for batch andauditing.CFG_SUBTASK_CONFIG_CONFLICT_TRAP: Configuration conflict is found during auditCFG_SUBTASK_CONFIG_CONFLICT_CLEAR_: Configuration conflict is resolvedCLI_BATCH_CONFIG_IN_PROGRESS_TRAP: Batch configuration commit is in progressCLI_BATCH_CONFIG_COMPLETE_TRAP: Batch configuration commit is successentityEnable entity change trapsTrap SNMPv2-MIB::sysUpTime.0 = Timeticks: (1487406) 4:07:54.06,SNMPv2-MIB::snmpTrapOID.0 = OID: SNMPv2-SMI::mib-2.47.2.0.1,SNMPv2-SMI::enterprises.6027.3.6.1.1.2.0 = INTEGER: 4Trap SNMPv2-MIB::sysUpTime.0 = Timeticks: (1488564) 4:08:05.64,SNMPv2-MIB::snmpTrapOID.0 = OID: SNMPv2-SMI::mib-2.47.2.0.1,SNMPv2-SMI::enterprises.6027.3.6.1.1.2.0 = INTEGER: 5Trap SNMPv2-MIB::sysUpTime.0 = Timeticks: (1489064) 4:08:10.64,Simple Network Management Protocol (SNMP) 1053
