Dell# show pe 10Codes: A - Active, I - InactiveReason: CTM - Card Type Mismatch, CAM - CAM ACL MismatchSVM - Software Version Mismatch, UE - Unknown ErrorOffline Reason: UNP - Unit Not Present,ICE - IPC CP Error, IRE - IPC RP ErrorISE - IPC Setup Error, CVE - Card Validation ErrorPE-ID assigned: 10Status: onlineSystem Mac: 00:01:02:03:11:01PE Up Time: 00:01:06PE Discovery Status: Provisioned PEUser Configured Cascade Ports: Te 1/0(A),Te 1/12(A)Cascade LAG: Po 268(Up)------------------------------------------------------------Stack-id Status Reason Type UnitMac No. of Ports------------------------------------------------------------0 online - C1048P 00:01:02:03:11:01 52Dell#NOTE: In the User-Configured Cascade Ports field, A (active) indicates that a C9010 port is up (noshutdown) and configured as a cascade port; I (inactive) indicates that a port is down and configured asa cascade port.Dell# show interface port-channel brCodes: L - LACP Port-channelO - OpenFlow Controller Port-channelA - Auto Port-channelI - Internally LaggedLAG Mode Status Uptime PortsA 268 N/A up 14:45:26 Te 1/0 (Up)Te 1/12 (Up)Dell#PE Selection LogicAfter you provision port extenders and power them on, the PEs come online according to the selection logicin the scenarios described in this section.• You may provision cascade ports for different PEs but connect the cascade ports to the same PE. In thiscase, only the PE with lowest PE ID comes online. In the following example, both cascade ports 1/0 and1/12 are cabled to the same PE. However, port 1/0 is provisioned for PE 10; port 1/12 is provisioned forPE 20. As a result, only PE 10 comes online. PE 20 remains offline and its configured cascade port isplaced in an error state.Dell# show running-config pe!feature extended-bridge!pe provision 10cascade interface TenGigabitEthernet 1/0stack-unit 0 type C1048Pstack-unit 0 priority 1!Port Extenders (PEs) 823