Examples of the show CommandsThe following example shows the show dot1p-queue mapping command.Dell(conf)# show dot1p-queue-mappingDot1p Priority: 0 1 2 3 4 5 6 7Queue : 0 0 0 1 2 3 3 3The following example shows the show dcb command.Dell#show dcb linecard 2 port-set 0DCB Status: Enabled, PFC Queue Count: 2linecard Total Buffer PFC Total Buffer PFC Shared Buffer PFC Available BufferPP (KB) (KB) (KB) (KB)-----------------------------------------------------------------------------2 0 11210 7488 2496 4992The following example shows the output of the show qos dcb-map test command.Dell#show qos dcb-map test-----------------------State :CompletePfcMode:ON--------------------PG:0 TSA:ETS BW:50 PFC:OFFPriorities:0 1 2 5 6 7PG:1 TSA:ETS BW:50 PFC:ONPriorities:3 4The following example shows the show interfaces pfc summary command.Dell# show interfaces tengigabitethernet 1/4 pfc summaryInterface TenGigabitEthernet 1/4Admin mode is onAdmin is enabledRemote is enabled, Priority list is 4Remote Willing Status is enabledLocal is enabledOper status is RecommendedPFC DCBx Oper status is UpState Machine Type is FeatureTLV Tx Status is enabledPFC Link Delay 45556 pause quantamsApplication Priority TLV Parameters :--------------------------------------FCOE TLV Tx Status is disabledISCSI TLV Tx Status is disabledLocal FCOE PriorityMap is 0x8Local ISCSI PriorityMap is 0x10Remote FCOE PriorityMap is 0x8Remote ISCSI PriorityMap is 0x8Dell# show interfaces tengigabitethernet 1/4 pfc detailInterface TenGigabitEthernet 1/4Admin mode is onAdmin is enabledRemote is enabledRemote Willing Status is enabledLocal is enabledData Center Bridging (DCB) 322
