• process-id the range is from 1 to 65535.• level-1, level-1-2, or level-2: assign all redistributed routes to a level. The default is level-2.• metric value the range is from 0 to 16777215. The default is 0.• match external the range is from 1 or 2.• match internal• metric-type: external or internal.• map-name: enter the name of a configured route map.Redistributing IPv6 RoutesTo add routes from other routing instances or protocols, use the following commands.NOTE: These commands apply to IPv6 IS-IS only. To apply prefix lists to IPv4 routes, use the ROUTER ISISmode previously shown.• Include BGP, directly connected, RIP, or user-configured (static) routes in IS-IS.ROUTER ISIS moderedistribute {bgp as-number | connected | rip | static} [level-1 level-1-2 |level-2] [metric metric-value] [metric-type {external | internal}] [route-mapmap-name]Configure the following parameters:• level-1, level-1-2, or level-2: assign all redistributed routes to a level. The default is level-2.• metric-value: the range is from 0 to 16777215. The default is 0.• metric-type: choose either external or internal. The default is internal.• map-name: enter the name of a configured route map.• Include specific OSPF routes in IS-IS.ROUTER ISIS moderedistribute ospf process-id [level-1| level-1-2 | level-2] [metric value][match external {1 | 2} | match internal] [metric-type {external | internal}][route-map map-name]Configure the following parameters:• process-id: the range is from 1 to 65535.• level-1, level-1-2, or level-2: assign all redistributed routes to a level. The default is level-2.• metric value: the range is from 0 to 16777215. The default is 0.• metric value: the range is from 0 to 16777215. The default is 0.• match external: the range is 1 or 2.• match internal• metric-type: external or internal.• map-name: name of a configured route map.To view the IS-IS configuration globally (including both IPv4 and IPv6 settings), use the show running-config isis command in EXEC Privilege mode. To view the current IPv4 IS-IS configuration, use the showconfig command in ROUTER ISIS mode. To view the current IPv6 IS-IS configuration, use the show configcommand in ROUTER ISIS-ADDRESS FAMILY IPV6 mode.Intermediate System to Intermediate System 600