Configure a LAG on ALPHAThe following example creates a LAG on ALPHA.Example of Configuring a LAGAlpha(conf)#interface port-channel 10Alpha(conf-if-po-10)#no ip addressAlpha(conf-if-po-10)#switchportAlpha(conf-if-po-10)#no shutdownAlpha(conf-if-po-10)#show config!interface Port-channel 10no ip addressswitchportno shutdown!Alpha(conf-if-po-10)#Example of Viewing a LAG Port ConfigurationThe following example inspects a LAG port configuration on ALPHA.Alpha#show int tengig 2/31TengigabitEthernet 2/31 is up, line protocol is upPort is part of Port-channel 10Hardware is Dell Force10Eth, address is 00:01:e8:06:95:c0Current address is 00:01:e8:06:95:c0Interface Index is 109101113Port will not be disabled on partial SFM failureInternet address is not setMTU 1554 bytes, IP MTU 1500 bytesLineSpeed 1000 Mbit, Mode full duplex, SlaveFlowcontrol rx on tx onARP type: ARPA, ARP Timeout 04:00:00Last clearing of "show interface" counters 00:02:11Queueing strategy: fifoInput statistics:132 packets, 163668 bytes0 Vlans0 64-byte pkts, 12 over 64-byte pkts, 120 over 127-byte pkts0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts132 Multicasts, 0 Broadcasts0 runts, 0 giants, 0 throttles0 CRC, 0 overrun, 0 discardedOutput Statistics136 packets, 16718 bytes, 0 underruns0 64-byte pkts, 15 over 64-byte pkts, 121 over 127-byte pkts0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts136 Multicasts, 0 Broadcasts, 0 Unicasts0 Vlans, 0 throttles, 0 discarded, 0 collisions, 0 wreddropsRate info (interval 299 seconds):Input 00.00 Mbits/sec,0 packets/sec, 0.00% of line-rateLink Aggregation Control Protocol (LACP) 630