Configuring Class-of-Service 1137Configuring CoS (CLI)This section provides information about the commands you use to configureCoS settings on the switch. For more information about the commands, seethePowerConnect M6220/M6348/M8024/M8024-k CLI Reference Guide atsupport.dell.com/manuals.Mapping Table ConfigurationBeginning in Privileged Exec mode, use the following commands in toconfigure the CoS mapping tables.CLI Command Descriptionconfigure Enter Global Configuration mode.interfaceinterface Enter Interface Configuration mode, whereinterface is replaced by gigabitethernetunit/slot/port, tengigabitethernetunit/slot/port, orport-channelport-channel number.classofservice dotlp-mappingpriorityMap an 802.1p priority to an internal traffic class fora switch. You can also use this command in GlobalConfiguration mode to configure the samemappings on all interfaces.classofservice trust {dot1p |ip-dscp | untrusted}Set the class of service trust mode of an interface.exit Exit to Global Config mode.exit Exit to Privilege Exec mode.show classofservice dotlp-mappingDisplay the current Dot1p (802.1p) prioritymapping to internal traffic classes for a specificinterface.show classofservice ip-dscp-mappingDisplay the current IP DSCP mapping to internaltraffic classes for a specific interface.show classofservice trust Display the current trust mode setting for a specificinterface.
