840 Configuring Link AggregationConfiguring Link Aggregation (CLI)This section provides information about the commands you use to configurelink aggregation settings on the switch. For more information about thecommands, see thePowerConnect M6220/M6348/M8024/M8024-k CLIReference Guide at support.dell.com/manuals.Configuring LAG CharacteristicsBeginning in Privileged EXEC mode, use the following commands toconfigure a few of the available LAG characteristics. Many of the commandsdescribed in "Configuring Port Characteristics (CLI)" on page 504 are alsoapplicable to LAGs.Command Purposeconfigure Enter global configuration mode.interfaceinterface Enter interface configuration mode for the specified LAG.Theinterface variable includes the interface type, which isport-channel, and the LAG number, for example port-channel 3.You can also specify a range of LAGs with the interfacerange port-channel command, for example, interfacerange port-channel 3-6 configures LAGs 3, 4, 5, and 6.descriptiondescription Configure a description for the LAG or range of LAGsport-channel min-linksminimumSet the minimum number of links that must be up inorder for the port channel interface to be declared up.exit Exit to Global Config mode.CTRL + Z Exit to Privileged EXEC mode.show interfacesdescription port-channelport-channel numberView the configured description for the specified LAG.show interfaces port-channel [port-channelnumber]View LAG information for the specified LAG or for allLAGs.
