Managing IPv4 and IPv6 Multicast 1213Configuring and Viewing MLDBeginning in Privileged EXEC mode, use the following commands toconfigure MLD on the switch and on VLAN routing interfaces and to viewIGMP information.Command Purposeconfigure Enter global configuration mode.ipv6 mld router Enable MLD on the switch.interface vlanvlan-id Enter Interface Configuration mode for thespecified VLAN.ipv6 mld router Enable MLD on the interface.ipv6 mld versionversion Set the version of MLD for an interface.Theversion variable can be 1 or 2.ipv6 mld query-intervalseconds Configure the query interval for the specifiedinterface. The query interval determines how fastMLD Host-Query packets are transmitted on thisinterface.The range forseconds is 0–3600 seconds.ipv6 mld query-max-response-timesecondsConfigure the maximum response time intervalfor the specified interface. It is the maximumquery response time advertised in MLD querieson this interface.The range forseconds is 0–25 seconds.ipv6 mld last-member-query-intervaltenthsofsecondsSet the last member query interval for the MLDinterface, which is the value of the maximumresponse time parameter in the group-specificqueries sent out of this interface.The range is 0–65535 milliseconds.ipv6 mld last-member-query-countcountSet the number of listener-specific queries sentbefore the router assumes that there are no localmembers on the interface.The range forcount is 1–20.CTRL + Z Exit to Privileged EXEC mode.
