racadm Subcommand Man Pages 155<binary data>SWI stack<binary data>Enter stack<binary data>Current task stack: 'IPEV' -#005e0000<binary data>where <binary data> is the binary information that was generated by the DRAC 4 firmware.Example output (when data is not available):FW d_cmdCoreDump: No CORE dump available.coredumpdeleteNOTE: To use this command, you must have Clear Logs or Execute Debug Commands permission.Table A-8 describes the coredumpdelete subcommand.Synopsisracadm coredumpdeleteDescriptionThe coredumpdelete command clears the area reserved for persistent storage of bus errorinformation. This operation is performed regardless of whether any bus error information iscurrently stored in the area reserved for this information.See the coredump command for information about displaying the bus error information.fwupdateNOTE: To use this command, you must have Configure DRAC 4 permission.Table A-9 describes the fwupdate subcommand.Table A-8. coredumpdeleteSubcommand Definitioncoredumpdelete Deletes the core dump stored in the DRAC 4.
