MVX9000 User Manual xiWARNING!Wait at least 2 minutes after all display lamps have gone out, and thenconfirm that the capacitors have fully discharged by measuring thevoltage between B1 and Ground using a multi meter set to measure DC.WARNING!Opening the Drive voids the warranty!WARNING!Make sure that all screws are tightened to the proper torque ratingshown in Table 3-3.WARNING!This equipment should be installed, adjusted, and serviced by qualifiedelectrical maintenance personnel familiar with the construction andoperation of the equipment and the hazards involved. Failure toobserve this precaution could result in bodily injury.WARNING!Use 75ºC Cu wire only or equivalent.WARNING!The rated voltage for AC motor drive must be equal or less than 240V(equal or less than 480V for 460V models, equal or less than 600V for575V models) and the mains supply current capacity must be equal orless than 5000A RMS (equal or less than 10000A RMS for the 40 hp [30kW] models).WARNING!Disconnect AC power before proceeding!CAUTION!There are highly sensitive MOS components on the printed circuitboards. These components are especially sensitive to static electricity.To avoid damage to these components, do not touch these componentsor the circuit boards with metal objects or your bare hands.CAUTION!Ground the MVX9000 using the ground terminal. The groundingmethod must comply with the laws of the country where the AC driveis to be installed. Refer to the Basic Wiring Diagram in Chapter 3.
