2 Engineering2.1 SmartWire-DTDX-NET-SWD... 08/14 MN04012009Z-EN www.eaton.com 132 Engineering2.1 SmartWire-DTSmartWire-DT is an intelligent wiring system and makes the reliable and easyconnection of switching devices, pilot devices and I/O components withoverriding bus systems possible. The components that are connected withSmartWire-DT are linked, e.g. to PROFIBUS-DP or CANopen communicationnetworks via gateways using SmartWire-DT masters.With the SmartWire-DT system up to 99 modules can be connected to forma network. Modules can include SmartWire-DT I/O modules or SmartWire-DTmodules for contactors, soft starters, drives or pilot devices. The electricalconnection is effected via a special 8-pole connecting cable and the relevantplugs.When equipped with a DX-NET-SWD… SmartWire-DT interface module,PowerXL variable frequency drives can be connected to a SmartWire-DTsystem and, as a result, to a higher-level PLC. SmartWire-DT can then beused to configure, control, and monitor these devices.2.2 LED (SmartWire-DT diagnostics LED)Table 2: Status of the SmartWire-DT diagnostics LED2.3 1-0-A switchThe 1-0-A switch‘s positions are as follows:• 1: Variable frequency drive is activated• 0: Variable frequency drive deactivated• A: switching command via SmartWire-DT→ This chapter uses the original English terms that appearthroughout a variety of specifications (e.g., SmartWire-DT,PROFIdrive).Color Status MeaningOrange Continuous light Switching command for variable frequency drive via SmartWire-DTflashing Switching command active, diagnostics availableGreen Continuous light Device is ready, error-freeFlashing (1 Hz) • addressing process in progress• after gateway/control section power On• after actuation of the configuration button on the gateway/controlsection• Module not in current configuration• invalid typeFast flashing (3 Hz) Incorrect position of the 1-0-A-switch→ Intermediate 1-0-A switch positions are not permitted, and willcause the device to stop and send an fault message.