0 About this Manual0.1 List of revisionsDX-NET-SWD... 08/14 MN04012009Z-EN www.eaton.com 30 About this ManualThis manual contains specific information designed to enable you to connecta DX-NET-SWD1 or DX-NET-SWD3 SmartWire-DT interface module to aPowerXL variable frequency drive and to use the relevant parameters toconfigure the module according to your specific needs.0.1 List of revisionsThe following significant amendments have been introduced since previousissues:0.2 Target groupThis manual, MN04012009Z-EN, is intended for engineers, electricians, andautomation technicians. Electrical engineering and physics-relatedknowledge and skills will be required in order to be able to commission thecorresponding devices. In addition, readers must be familiar with how to usethe SmartWire-DT system.0.3 Further manuals for this deviceFurther information can be found in the following manuals:On the topic “Variable frequency drive/Variable speed starter”• DC1 – MN04020003Z-EN• DA1 – MN04020005Z-EN• DE1 – MN040011ENOn “SmartWire-DT”:• “SmartWire-DT The system” – MN05006002Z-EN• “SmartWire-DT module” – MN05006001Z-EN• “SmartWire-DT Gateways” – MN05013002Z-DE0.4 Sources[1] Profile Drive Technology, PROFIdrive Technical Specification forPROFIBUS and PROFINET, Version 4.1, May 2006; Order No: 3.172PublicationdatePage Subject New Modifi-cationDeleted08/14 completely revised,DX-NET-SWD1 added ✓06/13 Initial issue→ The above mentioned manuals and further information can befound in the internet:www.eaton.eu/powerxl