S611 Soft Starter MN03902011E—May 2012 www.eaton.com 41Advanced Operation ModeCode Parameter Minimum Maximum Default NotesP.00 Device Address Port 1 254 1 Port A—Top cover portP.01 Modbus Baud Rate Port A 0 7 4 0 = 12001 = 24002 = 48003 = 96004 = 192005 = 384006 = 576007 = 115200P.02 Modbus Parity Port A 0 2 0 0 = Even (1 stop bit)1 = Odd (1 stop bit)2 = No parity (2 stop bits)3 = Even (2 stop bits)4 = Odd (2 stop bits)5 = No parity (1 stop bit)P.03 Device Address Port B 1 254 1 Port B —Hardwire portP.04 Modbus Baud Rate Port B 0 7 4 0 = 12001 = 24002 = 48003 = 96004 = 192005 = 384006 = 576007 = 115200P.05 Modbus Parity Port B 0 2 0 0 = Even (1 stop bit)1 = Odd (1 stop bit)2 = No parity (2 stop bits)3 = Even (2 stop bits)4 = Odd (2 stop bits)5 = No parity (1 stop bit)P.06 User Interface Edit Lock 0 1 0 0 = UIM editing enabled (unlocked)1 = UIM editing disabled (locked)This is the only parameter that can beedited when lockedP.07 User Display Parameter 0 10 0 Value displayed in TC LED0 = Thermal capacity (%)1 = Power factor2 = Line frequency3 = Residual ground current4 = Voltage imbalance (%)5 = Current imbalance (%)6 = Run time7 = Average pole temperature8 = Pole temp A phase9 = Pole temp B phase10 = Pole temp C phaseP.08 Configuration Reset N/A N/A 0 1 = Power cycle2 = Restore factory default parameterswww.comoso.com
