48 S611 Soft Starter MN03902011E—May 2012 www.eaton.comConfiguring the S611Entering values for the basic protection parameters and theadvanced configuration parameters can be accomplisheddirectly through the User Interface Module (UI). The UI or theNetwork connection may be used to configure all models ofthe S611 soft starter.Viewing and editing protection set-points can be performedin the Protection and Operation (P/O) mode. The followingdiagram outlines the procedure for modifying any of the setpoints.Note that the editing mode can be exited (without saving theparameter) value by pressing the Mode button.Functions that can be performed and parameters that can bemonitored include the following on the User InterfaceModule (UI):● Mode LED Indicators—Protection, Operation, Monitor● Units LED Indicators—Amps, Volts, kW, User Defined● Phase Indicator LED Indicators—Average, Phase A,Phase B, Phase C● Status LED Indicators—Ready, Fault● Alpha Numeric Display—Parameter values and Fault Codes● Function Keys—Mode/Cancel, Up, Down, Edit/Save, FaultLog, ResetEntering Basic Operating ParametersStep 1: Press Mode button until Protection or Operation (P/O) mode LED is lit.Step 2: Press Up or Down button until the desired P/O LED is lit. Display showsthe current parameter value.Step 3: Press the Edit/Save button. The display shows the parameter valuebut it is now flashing.Step 5: Press the Edit/Save button. The display now stops flashing and showsthe new parameter value that has been saved by the device.Mode/Cancel120Step 4: Use the Up/Down buttons to adjust the parameter to the desired value.110110120Edit/SaveEdit/Savewww.comoso.com