Eaton S611 User Manual

Also see for S611: Installation leaflet Quick start installation guide Installation leaflet

Contents

44 S611 Soft Starter MN03902011E—May 2012 www.eaton.comDisplay MessagesThe following display messages may appear on the S611 User Interface Module (UIM) toindicate status.Display MessagesMotor Protection/Basic Programming Set PointsThe 611 is capable of advanced, intelligent motor protection. Programming the basicprotection parameters can be accomplished directly through the User Interface Module (UI).More advanced control and protection parameters can also be programmed using the UI orover network communications.Viewing and editing protection set points can be performed in the Protection and Operation(P/O) mode. The following diagram outlines the procedure for modifying any of the set points.Note: The editing mode can be exited (without saving the parameter value) by pressing theMode/Cancel button.Motor Protection/Basic Programming Set PointsMessage DescriptiontOP Indicates that the top of the fault list has been reachedbOt Indicates that the bottom of the fault list has been reachedOFF The protection parameter is disabled.999 The display parameter exceeds the display range.F.XX Fault codes (see table on Page 27)E0X Error codes (see table on Page 47)A.XX Auxiliary relay codesStep 1: Press Mode button until Protection or Operation (P/O) mode LED is lit.Step 2: Press Up or Down button until the desired P/O LED is lit. Display showsthe current parameter value.Step 3: Press the Edit/Save button. The display shows the parameter valuebut it is now flashing.Step 5: Press the Edit/Save button. The display now stops flashing and showsthe new parameter value that has been saved by the device.Mode/Cancel120Step 4: Use the Up/Down buttons to adjust the parameter to the desired value.110110120Edit/SaveEdit/Savewww.comoso.com