S611 Soft Starter MN03902011E—May 2012 www.eaton.com 43User Interface MonitoringIn the monitoring mode, the up-button ( ) and down-button ( ) are used to scroll through theparameters that are available for display. When the end of the parameter list is reached (fromeither direction), the next button press wraps to the beginning or end of the list. The followingtable describes the operation of the monitoring mode.Operation of the Monitoring ModeAction Display Parameter Format (Example) LEDs ONDefault Average rms current x.xx if Avg <10xx.x if Avg <100xxx if Avg *100Mode–MonitorUnits–APhase–AVGStatus–ReadyDown–( ) Phase A rms current x.xx if Ia <10xx.x if Ia <100xxx if Ia *100Mode–MonitorUnits–APhase–IA | LI-L2Status–ReadyDown–( ) Phase B rms current x.xx if Ib <10xx.x if Ib <100xxx if Ib *100Mode–MonitorUnits–APhase–IB | L2-L3Status–ReadyDown–( ) Phase C rms current x.xx if Ic <10xx.x if Ic <100xxx if Ic *100Mode–MonitorUnits–APhase–IC | L3-L1Status–ReadyDown–( ) Average rms voltage 480 Mode–MonitorUnits–VPhase–AVGStatus–ReadyDown–( ) Phase A rms voltage 480 Mode–MonitorUnits–VPhase–IA | LI-L2Status–ReadyDown–( ) Phase B rms voltage 480 Mode–MonitorUnits–VPhase–IB | L2-L3Status–ReadyDown–( ) Phase C rms voltage 480 Mode–MonitorUnits –VPhase–IC | L3-L1Status–ReadyDown–( ) Total motor power X.XX if kW <10XX.X if kW <100XXX if kW *100Mode–MonitorUnits–kWPhase–AVGStatus–ReadyDown–( ) Motor thermal capacity/Userselected0–100 Mode–MonitorUnits–TCPhase–NoneStatus–Readywww.comoso.com